Ruger Pistol Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
Hello,

Long time lurker first time poster here from Atlanta. Anyways I have enjoyed reading on the site but found a reason to finally post. I am trying to figure out how to remove the extractor from my LCP slide. Does anyone have any experience doing this?
 

·
Registered
Joined
·
2,215 Posts
andyzx6r said:
Hello,

Long time lurker first time poster here from Atlanta. Anyways I have enjoyed reading on the site but found a reason to finally post. I am trying to figure out how to remove the extractor from my LCP slide. Does anyone have any experience doing this?
take a dental pick and insert it right behind the extractor and push backward, that will push the pin and spring away from the extractor. If u have a magnet, then just pull the extractor out from the slide. They are alittle finicky to get out. If you are just doing it to be doing it then my advise is to leave it alone. You should be able with ease to pressure spray that area and clean that extracotor without taking it all apart. A drop of oil behind that extractor to run down the channel is all that is needed. again unlessnecessary LEAVE IT ALONE..
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top