Ruger Pistol Forums banner

1 - 6 of 6 Posts

·
Registered
Joined
·
12 Posts
Discussion Starter #1
Has anyone on this site adjusted the sights on their lcp custom model? I had assumed you would use an allen wrench to loosen them then move them to the desired location but the round hole in front of the rear sights doesn't seem to accommodate an allen wrench.

Can the front sights be replaced with a higher or lower sight?

Thanks for your help.

Charlie
 

·
Super Moderator
Joined
·
4,595 Posts
Call Ruger customer service and ask them how to adjust the rear sight. They are pretty helpful on things Like this.
 

·
Registered
Joined
·
2,503 Posts
I have found an .060, or 1/16 allen wrench should be used to loosen the rear sight and after moving it to the right or left as needed, simply tighten it back up. Den
 

·
Registered
Joined
·
470 Posts
I have found an .060, or 1/16 allen wrench should be used to loosen the rear sight and after moving it to the right or left as needed, simply tighten it back up. Den
^^^That makes much sense, and isn't there some advice in the manual that came with said handgun? Should be something in there to address sight adjustment.
 
1 - 6 of 6 Posts
Top